Product Search
Looking For a Specific Product? Use the Search Bar Below.
Looking For a Specific Product? Use the Search Bar Below.
Used for a second Coil or to replace a broken one on your Minelab Equinox Coil.
Minelab Replacement Rubber Washer Kit for the GPZ Metal Detector
Minelab Search Coil Hardware Kit for GPZ 7000 Metal Detector.
Minelab X-Terra Lower Shaft
Lower Shaft for E-Trac, Explorer SE Pro & Safari
Shaft, Lower FBS Tall Man, 24.5" Long
Suits GPX Series and Eureka Gold detectors
Replacement search coil hardware and lower shaft assembly for the Minelab GPZ 7000 metal detector.
Connect 6.3mm (1/4-inch) headphones to your detector or WM 08 Module with this handy adaptor.The 3.5mm (1/8-inch) end forms a waterproof connection...
View full detailsMinelab Pro-Swing 45 Harness Replacement Strut & Crossbar Kit.
Minelab Replacement Armrest with Stand & Screws.This replacement armrest stand is made for the Minelab GPZ 7000 Metal Detector.
Minelab Battery Seal O-Rings & Screw-On Cap.This kit includes three O-ring waterproof seals for the GPZ 7000 & CTX 3030 battery mount cap a...
View full detailsMinelab Pro-Swing 45 Spares Kit with plastic J-Strut, Bungee Cord, R-Clip, & Velcro Strip.This is suitable as a replacement, or for those peopl...
View full detailsHandy 2-way USB charger that plugs into a standard car charging socket so you can charge on the go.
Four-way USB AC charger with universal plug pack. Includes 4-port USB wall charger and 3 plug adapters.
Minelab 12 Volt Car Charger.This car charger plugs into a 12 Volt DC automotive lighter socket for convenient, mobile charging when away from mains...
View full detailsMinelab GPX 7000 Metal Detector Adaptor, Charger and Cable Kit.This kit contains the 12 Volt adaptor for the battery cradle, the 120 volts and 240 ...
View full detailsFlexible Hinge for GPZ 7000
One of the biggest complaints we've heard about the SDC 2300 was that the armrest was too stiff and uncomfortable. Well, Minelab was listening, bec...
View full detailsThis special Ferrite Ring is for ground balancing your GPZ 7000 gold detector, which requires a completely new type of ground balancing. Everyon...
View full detailsBattery Lid Tether, SDC-2300
Individual Coil Hardware for Minelab CTX, ETrac, Explorer, FBS. Does not fit Equinox series. Includes two rubber washers, nut and bolt.
Tether and Cap for Equinox Headphone Connector This is a replacement tether and cap for the headphone socket on an Equinox 600, 700, 800, 900, X-T...
View full detailsMinelab Uni-Shaft Bolt for Gold Monster 1000 Metal Detector 4001-0025
Shaft for the Minelab GPX 6000. Extends up to 36" inches.
Minelab Manticore Coil Hardware (bolt + washers). Comes with one bolt + two washers.